|
The VAXBI bus (VAX Bus Interconnect bus) was a computer bus designed and sold by the Digital Equipment Corporation (DEC) of Maynard, Massachusetts. The bus was an advanced, configuration-free synchronous bus used on DEC's later VAX computers. Like the Unibus and Q-Bus before it, it used memory-mapped I/O but had 32-bit address and data paths. The VAXBI was a multiplexed bus with fully distributed arbitration and geographic addressing. All of the logic required to implement a VAXBI interface was contained within a single custom integrated circuit (the "BIIC") and the physical layout and printed wiring board layup for compliant cards was tightly specified, right down to the location of the dual amber status LEDs that were required. The portion of the card that was reserved for the bus interface was referred to as "the VAXBI corner". VAXBI licensees were given the appropriate engineering drawings to allow them to exactly replicate a compliant card. VAXBI cards mounted into backplanes using a ZIF connector; depending on the backplane design, cards could be loaded from the top or the front side of the backplane. No cable connections were permitted on the cards; all connections were made via three uncommitted rows of backplane connectors. Similarly, no configuration jumpers were permitted on the cards; all setup was done by jumpers inserted on the backplane connectors or via software configuration. Originally conceived by its engineers to be an open bus, it was forced to be a tightly licensed bus by Digital's marketing and management, and was not nearly as successful as had originally been hoped-for. It was used in the VAX 6000, VAX 8000 (82xx, 83xx, 85xx, 87xx, 88xx models) and the VAX 9000 systems and also on the MIPS R3000 based DECsystem 5800 series. A PDP-11 implementation (the PDP-11/27) was also envisioned but never advanced beyond the concept stage. ==References== 抄文引用元・出典: フリー百科事典『 ウィキペディア（Wikipedia）』 ■ウィキペディアで「VAXBI Bus」の詳細全文を読む スポンサード リンク
|